Skip to main content

Electrical and MEP

12 june 2019

Ext...ARI tall guy

Internal bc mc jitni gali du utna kam h

Electrical
1.Insulated neutral system and earth neutral system diff.
2.paralleing of generator
3.IR test
4. Msb safeties
5. Ip full
1ques tha vo samjh ni aya ptani khn se pucha tha

1. Boiler saftey valve overhaul and checks full
2. Least count of micrometer

M.e Fuel pump ka 1ques ata ni tha

Internal sirf nipta rha tha sabke oral aj

Na decider kuch ni

Give electrical only

Labels:

Comments

Post a Comment

Popular posts from this blog

Difference between Attemperator and De-superheater

Attemperator are fitted in order to keep the steam temperature in the final stages of the superheater within certain desired limits . This is done for two main reasons . 1. The most important is the protection of the superheater tube material from the effects of overheating. *Mild steel superheater tubes tubes should not be subjected to steam temperatures in excess of 455℃. 2. The formation of bonded deposits on superheater tubes can be reduced if steam and gas streams within certain temperature ranges are prevented from coming into contact of each other. De-Superheater is used to reduce the temperature of a quantity of superheated steam and make it suitable for used in auxiliary services requires low temperature or saturated steam . *The reason for doing this way rather than by taking the saturated steam direct from steam drum , is to protect the superheater , these must be protected against overheating under all conditions of load by circulating steam through them . *Al...
Post a Comment
Read more

Why Distilled water is not circulated in the pipelines ?

1.Why Distilled water is not circulated in the pipelines ? Ans. In Fwg distilled water is generated still it is not directly used in Boiler without chemical dosing even it is free from contaminants . The reason to the question is distilled water ready absorption carbon dioxide and tends to become slightly acidic which can cause corrosion . 2. What is the highest temperature at which a fuel of 60 deg Flash point should be heated to achieve a certain viscosity? Ans. Less than 20 deg of its Flash point i.e 40 deg . And the reason is near its flash point tempeature fuel starts to vaporise 3. What is the percentage water of get distillated from 100% of sea water? Ans. It is around  50% rest do formation of brine , scale of carbonates and bicarbonates .
3 comments
Read more