Skip to main content

6 June 2019

MEP

1-Lubrication in 4Stroke- ram lubrication, LO property and tests

2-Types of bearing in 4stroke

3-Types of welding- welding deffects, all about electrode nomenclature and which electrode to use for welding Mild steel plates

4- Lathe parts, types of tools used in lathe, lathe operation.

5- Nomogram

6- Types of heat exchanger- leak detection in shell and tube type, safeties to be followed, at what pressure and how will u secure the tube stack during the test

DECIDER- LNG tank construction!

Labels:

Comments

Post a Comment

Popular posts from this blog

Wire drawing effect

Wire drawing effect : It is erosion or scoring of valve seat and disc material of the valve . Causes : 1. Due to differential pressure across the valve . 2. Thermal and mechanical damages . Effects : Valve is unable to isolate the line and fails in sealing . Gas and liquid will leak from the wire and scratch like groove .
Post a Comment
Read more

Difference between Attemperator and De-superheater

Attemperator are fitted in order to keep the steam temperature in the final stages of the superheater within certain desired limits . This is done for two main reasons . 1. The most important is the protection of the superheater tube material from the effects of overheating. *Mild steel superheater tubes tubes should not be subjected to steam temperatures in excess of 455℃. 2. The formation of bonded deposits on superheater tubes can be reduced if steam and gas streams within certain temperature ranges are prevented from coming into contact of each other. De-Superheater is used to reduce the temperature of a quantity of superheated steam and make it suitable for used in auxiliary services requires low temperature or saturated steam . *The reason for doing this way rather than by taking the saturated steam direct from steam drum , is to protect the superheater , these must be protected against overheating under all conditions of load by circulating steam through them . *Al...
Post a Comment
Read more