Skip to main content

Safety , Motor , Mep

15/04

Pratishtha Bhavan
Safety
Load line marking and cross questions
Ism objective
ISPS level
Co2 system safety
Mlc
Mep & motor
4s valve timing dia and asked me to show overlap period
Jcw temp high alarm what will be your action
Black smoke from a/E at funnel your action
T/C blower side construction
Lube oil test without test kit
Why we maintain phosphate level in boiler water
Chloride test
High salinity alarm repeatedly coming what will be your action
How to charge oil in refrigeration
Pipe fabrication
How to change fuel setting

Labels:

Comments

Post a Comment

Popular posts from this blog

Why Distilled water is not circulated in the pipelines ?

1.Why Distilled water is not circulated in the pipelines ? Ans. In Fwg distilled water is generated still it is not directly used in Boiler without chemical dosing even it is free from contaminants . The reason to the question is distilled water ready absorption carbon dioxide and tends to become slightly acidic which can cause corrosion . 2. What is the highest temperature at which a fuel of 60 deg Flash point should be heated to achieve a certain viscosity? Ans. Less than 20 deg of its Flash point i.e 40 deg . And the reason is near its flash point tempeature fuel starts to vaporise 3. What is the percentage water of get distillated from 100% of sea water? Ans. It is around  50% rest do formation of brine , scale of carbonates and bicarbonates .
3 comments
Read more

Difference between Attemperator and De-superheater

Attemperator are fitted in order to keep the steam temperature in the final stages of the superheater within certain desired limits . This is done for two main reasons . 1. The most important is the protection of the superheater tube material from the effects of overheating. *Mild steel superheater tubes tubes should not be subjected to steam temperatures in excess of 455℃. 2. The formation of bonded deposits on superheater tubes can be reduced if steam and gas streams within certain temperature ranges are prevented from coming into contact of each other. De-Superheater is used to reduce the temperature of a quantity of superheated steam and make it suitable for used in auxiliary services requires low temperature or saturated steam . *The reason for doing this way rather than by taking the saturated steam direct from steam drum , is to protect the superheater , these must be protected against overheating under all conditions of load by circulating steam through them . *Al...
Post a Comment
Read more